How to change a lock step 1.
Changing door locks do it yourself.
Remove the two visible bolts in the turn assembly plate and then remove the turn plate.
Begin by removing the screws from the door knob on the interior side of your door.
Use a phillips head screwdriver to unfasten the two or three screws located on the inside knob plate.
Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening.
You may also need to use a wire tool or a paper clip.
Purchase a new lock.
Now put the door handle together in the opposite way that you took it apart.
Before you begin make sure you have a new door lock set and a screwdriver or drill.
Measure the back set of the door by measuring from the door latch to the middle of the door knob.
Everything should work without having to put new holes unless you change the style of your door knob.
Open the door and.
Remove the old lock.
Replacing the lock on a front door.
Put the two pieces together and then screw in the door piece.
Chisel out any uneven recesses in the latch so that your new latch will fit perfectly.
Slide the outside parts of the.
Remove the screws from the old lock on the inside of the door.
Step 1 purchase a new lock.
Install your new lockset making sure that the keyed section is on the outside.
Go to the store and purchase a new lock.
Step 1 prop the door open.
In apartment complexes this is now the most common way of changing locks on a door.
Rekeying involves realigning the pins and springs in the inner workings of the lock in order to match the lock.
Remove the old deadbolt.
Step 4 insert new tongue plate.
Door lock installation 1.
Changing locks on doors.
Then screw in the new door knob piece and tighten it with your screwdriver.
Purchase the same lock from a local hardware store.
Changing the lock yourself examine the latch of the door to determine what brand of lock it is.
As stated above you need access to both sides of the door at the same time when changing locks.
This allows you to pull the door.
Installing the new lock is an.
Insert the pins and reassemble the lock dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to.
Step 3 remove screws from tongue plate.
Then remove each side s door knob by pulling them away from the door.
Step 2 remove the screws from two halves of lock.
Step 2 remove the old lock.
Once the new pins are in reverse the steps to reassemble the lock.
Test the latch operation and the locking.
